5e Dmg 274
Blood Hunter Class for D&D 5e (2020) Blood Hunter - A Martial Class for 5th Edition Dungeons & Dragons Often feared or misunderstood, and driven by an unending drive to destroy the wicked, blood hunters are clever, arcane warriors who have bound their essence to the dark creatures they hunt to better stalk and survive their prey. Cavo categ.5e f/utp 4x2xawg24/1 rj45 bobina di legno d.1000. Display d13 1 poloxsegmento 24v com negativo dmg scatola piastra 02f s dmg. Nerdarchy the News Letter- 5E D&D DMG Villainous Class Options 5th Edition Dungeons and Dragons Dungeon. Creating NPCs/Monsters in 5e really isn't any different than it was in previous editions. The definition of CR changed, but how you make an encounter is the same. Determine the CR first. What CR do you want the Cleric Wight to be. Then look at the CR table on page 274, you want the HP and damage necessary to make that happen.
While messing around with monster creation, I started comparing 5e Monster Manual creatures with the 5e guidelines for creating monsters (DMG page 274). Based on my number crunching, it looks like the DMG’s central monster creation chart, “Monster Statistics by Challenge Rating”, isn’t in line with the Monster Manual, and if you try to follow it you will get monsters that don’t look much like Monster Manual monsters.
This may be widely known and only new to me, but I haven’t found anything definitive or official on it. A fairly cursory search only turns up a few argumentative message board discussions and some pretty good Howling Tower posts (such as https://koboldpress.com/howling-tower-monster-stats-part-2/ where Steve Winter graphs the discrepancies but backs off the conclusion that the DMG chart is incorrect.
In this post, I’ll try to show the data that suggests to me that the chart is wrong.
Note: the process of creating a monster stat block is long and convoluted: according to the DMG it’s a 20-step process (!) and one of the steps involves executing another 4-step process detailed elsewhere. So there’s lots of room for error, and I could have a lot of things wrong. But the basic process is: figure out the monster’s Defensive CR, which is primarily determined by HP but modified by AC, resistances, and some traits; figure out its Offensive CR, which is primarily determined by average damage over three rounds of combat, modified for burst damage, area of effects, and various traits and abilities, and also by attack bonus or spell save DC; and then average the offensive and defensive numbers to get the final CR.
Hit Points
The first clue that the DMG chart is wrong is in the hit points column of the chart. According to the chart, for instance, a CR 1/4 monster has 36-49 HP. However, let’s look at some CR 1/4 monster hit points. Boar, 11 HP. Goblin, 7 HP. Skeleton, 13 HP. Wolf, 11 HP. The CR 1/4 monster with the highest HP is the mud mephit, with 27 HP, still significantly less than the low end of the DMG-suggested hit point range.
Here’s a chart of the DMG-suggested Hit Points versus the average hit points per level from the Monster Manual: purple bar is the DMG’s Hit Point recommendations by CR, blue bar is the actual average HP from the Monster Manual.
That weird dip at CR 18 is because the demilich is the only CR 18 monster. And in fact, there are so few data points above level 10 that any analysis above level 10 should be taken with a grain of salt. Even ignoring the demilich and the dearth of high level data, you can see that the Monster Manual Hit Points skew way low.
The DMG monster creation rules have lots of adjustments to be made: monsters with lots of resistances and immunities are to have their “effective HP” adjusted upwards; and defensive abilities, such as damage transfer, regeneration, or magic resistance also adjust the effective HP. However, on examination, these adjustments don’t actually account for the extra HP in the DMG chart. In fact, they don’t do much at all. Examine the following chart:
In the chart above, “mm no defenses” means those monsters with few resistances and no significant defensive abilities. You’d expect these monster to have the highest hit points. “mm low resistance” are the monsters with few resistances, whether or not they have defensive abilities. “mm high resistance” means those monsters with more than 3 resistances or immunities: you’d expect these monsters to have the lowest hit points. (Many of these bars are broken because there are CRs at which there are no monsters which meet these qualifications.)
In fact, below level 12 – where we have enough data points to do reasonable analysis – there are no significant hit point differences between monsters with high special defenses/resistances/immunities and those without. At high levels, it is plausible that high-immunity monsters may have lower hit points, though we really need more data points to be sure. However, the overall trend lines are clear: none of these groups of monsters has anything like the hit point totals recommended in the DMG – even the no-defense brutes.
Conclusion: In the Monster Manual, hit points are much lower than the values presented in the DMG. Furthermore, special defenses, resistances and immunities don’t seem to be related to hit points.
Armor Class
Now let’s add armor class into the analysis. In the DMG, hit points and armor class are both used to determine “defensive CR” so perhaps it doesn’t make sense to analyze one without the other.
First of all, a simple analysis of real Monster Manual AC versus expected DMG AC.
Apart from high levels, Monster Manual and DMG ACs are close: usually within a point of AC.
Could Armor Class solve our Hit Point problems? Perhaps low-AC monsters have proper DMG Hit Point values?
Here is a chart of the average hit points of monsters grouped by AC.
“Low ac hp” is HP of the monsters with AC lower than the DMG AC value. You’d expect these guys to have high hit points. “High ac hp” have higher than average AC and theoretically should have lower than average hit points. “Target HP” are the monsters whose AC exactly matches the DMG AC expectations.
As you can see, below level 11, there is no significant difference in HP between those monsters with high and low HP. Above level 11, things are swingy as usual because of fewer data points, but there is no obvious through line that suggests that there is any relationship between AC and HP.
Conclusion: In the Monster Manual, AC values are on par with those presented in the DMG. Hit points and AC do not seem to be correlated in any meaningful way.
Damage
It takes quite a few steps to calculate a monster’s “average” damage according to the instructions in the Monster Manual. The process is: figure out the average damage for the first 3 rounds of combat. Assume that all monster attack hits and all hero saving throws fail. All area attacks hit two people, and all ongoing effects (like being swallowed) last for one turn. Effects like Charge or Pounce happen once.
After all these calculations, here are the Monster Manual average damages by CR, compared to the DMG expectations.
(The gap in the blue line is for the demilich, the only CR 18 monster, whose max damage is hard to calculate.)
The Monster Manual damage is fairly close to the DMG expectation, though generally 10% to 20% low. This is odd: Monster Manual hit points are too low according to the DMG rubric, and damage is low too? It seems as if Monster Manual monsters are just weaker than the DMG suggests. But let’s do some further analysis to damage.
Perhaps monsters have a higher “effective hit points” because of special attack modes. If this is the case, those monsters with special attack modes should have lower hit points than simple monsters. To test this, I’ll separate out those monsters with powerful attack modes that don’t do direct damage, like charm, stun, paralysis, and instakill abilities.
As usual, below level 11 where we have the most data, there is no damage difference between monsters with and without special attack modes. At high levels, there are variations, but there is no clear winner.
Maybe there is some relationship between damage and hit points? Perhaps monsters with lower hit points do higher damage, and vice versa?
To test this, I’ll graph the damage dealt by below-average-HP monsters and above-average-HP monsters separately.
Again, below level 11, there is no difference at all between the damage output of beefy and glass-jawed monsters, and at high levels the correlation isn’t clear. If anything, there may be a slight reverse correlation with beefier monsters doing more damage.
Conclusion: The damage output of Monster Manual monsters is slightly lower than the DMG expectations. It’s not correlated with special attack modes or with hit points.
Attack bonus
We have another important value to look at: attack bonus. How do the monster manual attack bonuses compare to the DMG values? And do they correlate to any other monster stats?
First of all, the attack bonus numbers:
Attack bonuses are WAY off. Monster Manual values are consistently too high compared to DMG values throughout – as much as 5 points too low at level 24 (+12 vs +17).
This is starting to make sense. I think the DMG values are an early draft of the monster formulae. I bet that at some point, the developers decided that they needed to raise the accuracy and lower the damage of monsters, aiming for the same total damage. The DMG chart never got updated.
While we’re here, let’s just check for a few more correlations. Do high-accuracy monsters have lower damage output, or have fewer hit points? My guess is no, since we’ve hardly found any correlations yet.
Not only does attack not balance anything out, there may be a reverse correlation: hi-accuracy monsters also tend to be slightly higher-damage and higher-hit point than normal. In other words, within a given CR, some monsters are better all-round than others.
Conclusion: Attack bonus in the Monster Manual is way lower than in the DMG chart, and doesn’t correlate with any other monster attributes.
Save DC
Since we’ve come this far, we might as well look at the last column in the DMG chart: save DC.
The save DCs in the Monster Manual are quite different from those in the DMG chart. The DMG DCs are much flatter, ranging from 13 to 23, while the actual DCs range from 10 to 24. I don’t think I need to do a lot of analysis on DCs.
Now what?
5e Dmg 274 Character
It seems clear to me that the Monster Statistics by Challenge Rating isn’t the up-to-date version of the monster creation formulae. I bet it was accurate as of some iteration of D&D Next and never got fully updated.
It’s also apparent that there is not a lot of correlation between any monster stat and any other stat. All the complicated DMG steps involving adjusting and averaging don’t actually hold up to examination when we look at the Monster Manual monsters. The actual process seems to be something like
1. Start with appropriate numbers based on CR
2. Adjust any stat or two up and down, and add any trait or feature, based on story. Don’t make any further adjustments.
Which is great for us! This two-step system is way easier than the 20-step DMG version. We can even do it on the fly! All we need is an accurate CR-to-statistics chart.
Give me a few days: I’ll try to come up with a new monster-creation chart that will match Monster Manual monster math, and that is small enough to fit, say, on a business card.
In the meantime, here is a copy of the monster-stat TSV file I used to generate these tables. Please feel free to validate the monster stats, validate or invalidate my calculations, correct my assumptions, prove me wrong, or whatever else you want to do with this stuff.
5e Dmg 274 Class
Next: more numbercrunching: we look at Mordenkainen’s Guide